Mcmurdo NAV6 Betriebsanweisung PDF herunterladen (Seite 48)

Nav6 Plus Navtex System User Guide

TESTING THE NAV6 AFTER INSTALLATION

TESTING THE NAV6 AFTER INSTALLATIONTESTING THE NAV6 AFTER INSTALLATION

TESTING THE NAV6 AFTER INSTALLATION

• Carefully check all connections before applying power.

• Switch on the power supply by closing the 1.5A circuit breaker or

power panel switch.

• Check that the red LED illuminates

for approximately 8 seconds and

then goes out and the start-up page

appears on the Nav6 display. The

start-up progress bar at the bottom

of the page will disappear when the

system is ready to use. Press any

key to show the next screen.

• Check that the sensor is working.

Check that both the ‘490’ and the

‘518’ icon appear on the status line

at the top of the Navtex display.

If the correct icons do not appear,

then switch off the power supply

and check the sensor data and

power connections; check that you

have not swapped the sensor DATA

A and DATA B wires.

• Check that the NMEA input is working. When the display is

receiving GPS data the ‘GPS’ icon will appear on the status line

at the top of the Navtex display. If the icon does not appear,

ensure that the NMEA source is operating and check the NMEA

data connections; you may have to swap the NMEA DATA A and

DATA B wires.

MAINTENANCE AND TROUBLE SHOOTING

MAINTENANCE AND TROUBLE SHOOTINGMAINTENANCE AND TROUBLE SHOOTING

MAINTENANCE AND TROUBLE SHOOTING

Cleaning

CleaningCleaning

Cleaning

The Nav6 Navtex System may be cleaned when necessary by

wiping with a cloth dampened with fresh water. Do not use solvents.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Keine Kommentare

Mcmurdo NAV6 Betriebsanweisung Seite 48